Section
03
Audio Adjustments
CUSTOM
Custom
FLAT
Flat
SUPER BASS
Super bass
! CUSTOM is an adjusted equalizer curve
that you create. If you make adjustments to
an equalizer curve, the equalizer curve set
ting is memorized in CUSTOM.
! When FLAT is selected, no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
1
Use MULTI-CONTROL to select
PRESET EQUALIZER.
2
Press MULTI-CONTROL to display the
setting mode.
3
Turn MULTI-CONTROL to select the
equalizer.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Adjusting equalizer curves
The factory supplied equalizer curves can be
adjusted to a fine degree (nuance control).
1
Use MULTI-CONTROL to select
EQ SETTING 1.
2
Press MULTI-CONTROL to display the
setting mode.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
the segment in the following order:
L (low) M (mid) H (high)
4
Turn MULTI-CONTROL to adjust the
level of the equalization band.
+6 to –6 is displayed as the level is increased
or decreased.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
# You can then select another band and adjust
the level.
24
En
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (LOW/MID/HI).
! If you make adjustments, CUSTOM curve
is updated.
Level (dB)
Center frequency
1
Use MULTI-CONTROL to select
EQ SETTING 2.
2
Press MULTI-CONTROL to display the
setting mode.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
the segment in the following order:
Band Frequency Q factor
4
Turn MULTI-CONTROL to adjust the se-
lected segement.
Band
LOW (low) MID (mid) HI (high)
Frequency
Low: 40HZ 80HZ 100HZ 160HZ
Mid: 200HZ 500HZ 1KHZ 2KHZ
High: 3KHZ 8KHZ 10KHZ 12KHZ
Q factor
2N 1N 1W 2W
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Adjusting loudness
Loudness compensates for deficiencies in the
low and high sound ranges at low volume.
1
Use MULTI-CONTROL to select
LOUDNESS.
2
Press MULTI-CONTROL to display the
setting mode.
Q 2W
Q 2N
Frequency (Hz)