Forward/Reverse Switch Operation; Clutch Torque Setting - Greenlee LDD-216 Manual De Instrucciones

Operation—Power Tool (cont'd)

Forward/Reverse Switch Operation

• If the bit becomes jammed, immediately release
the trigger to prevent an overload which can
damage the battery pack or motor. Use reverse
motion to loosen jammed bits.
• To prevent damage, do not operate Forward/
Reverse switch until the bit comes to a complete
stop.
• Do NOT operate the Forward/Reverse switch
when the trigger switch is on. The battery will dis-
charge rapidly and damage to the unit may occur.
Forward
Switch lock
Forward Rotation Switch Operation
1. Push the switch for forward (clockwise) rotation.
2. Depress the trigger slightly to start the tool slowly.
3. The speed increases with the amount of depres-
sion of the trigger for efficient tightening of
screws and drilling. The brake operates and the
chuck stops immediately when the trigger is
released.
4. After use, set the switch to its center position
(switch lock).
Reverse Rotation Switch Operation
1. Push the switch for reverse (counterclockwise)
2. Depress the trigger slightly to start the tool slowly.
3. After use, set the switch to its center position
Switch Lock Operation
Push the switch to its centered position to lock the
tool. In the switch lock position, the trigger will not be
able to be depressed and the tool will not be allowed
to operate.

Clutch Torque Setting

Reverse
LDD-216: Adjust the torque to one of the 18 clutch
settings for driving fasteners or the drill setting
hole-making operations.
LHD-216: Adjust the torque to one of the 18 clutch
settings for driving fasteners, or the drill setting
hammer setting
Note: Always stop operating the tool and disengage
it from the work before rotating the clutch handle to
switch between the drill and hammer settings.
The lower clutch settings deliver less torque than the
higher clutch settings. During operation a ratcheting
sound may be heard; release the trigger. This sound
indicates that the clutch is slipping because the driving
operation has overcome the available torque for the
engaged clutch setting.
For operations that require higher torque, use the low
speed setting.
12
rotation. Check the direction of rotation before
use.
(switch lock).
Test the setting before actual operation.
for hole-making operations.
Set the scale at this mark (
for
or
)