Speed Selection; Bit-Locking Function; Control Panel - Greenlee LDD-216 Manual De Instrucciones

Operation—Power Tool (cont'd)

Speed Selection

• Check the speed selector switch before use.
• Use at low speed when high torque is needed
during operation. (Using at high speed when
high torque is required may cause a motor
breakdown.)
• Do not operate the speed selector switch (LOW-
HIGH) while pulling on the speed control trigger.
This can cause the rechargeable battery to wear
quickly or damage the internal mechanism of the
motor.
Choose a low or high speed to suit the application. The
lower speed setting allows for higher torque operation.
When the word "High" is visible, the tool is in the high
speed setting. When the word "Low" is visible, the tool
is in the low speed setting.
LOW
The more the variable speed control trigger is pulled,
the higher the speed becomes.
Note: When the brake operates, a braking sound may
be heard. This sound indicates engagement of the bit
lock.

Bit-locking Function

With the trigger switch not engaged and a screwdriver
bit locked in place, the tool can be used as a manual
screwdriver (up to 353 in-lb or 40 Nm).
Note: There will be a little play in the chuck, but this is
not a malfunction.
This feature is handy for tightening screws that require
more torque than the maximum torque of the driver
(position on the clutch), for confirming the tight-
ness of a screw, or to loosen an extremely tight screw.
HIGH
13

Control Panel

• DO NOT STARE INTO WORK LIGHT. Use of controls
or adjustments or performance of procedures
other than those specified herein may result in
hazardous radiation exposure.
• Do not use it as a substitute for a regular
flashlight.
(1)
LED Light (1)
Note: To use the LED light, depress the trigger once.
Press the LED light button.
Pressing toggles the LED light on and off.
The light illuminates with very low current, and it does
not adversely affect the per-
formance of the driver during
use or its battery capacity.
The built-in LED light is
designed to illuminate the
small work area temporarily.
After installing the battery or
if tool has been idle for more
than 5 minutes, the work light will not illuminate until
the trigger has been initially depressed.
LDD-216 • LHD-216
(3)
(2)