GRAVEDA GRASPRESSO GP50-5-7 Manual De Instrucciones página 30

Now the Press begins the process and the countdown based on the
previously established time. After the timer has expired, you can open
the press carefully. Attention: the plates are hot! You can stop the timer
beep after the process is completed by pressing the timer buton or
restart the timer.
Commissioning
1. Press the setting buton to access the temperature
setting for the two heating plates. On the control
panel, the page with the temperature display will
flash.
2. Now press the "up" or "down" buton to set the
desired temperature.
3. Press the setting buton again to enter the time
setting mode. On the control panel, the page with
the time setting flashes.
4. Now press the "up" or "down" buton to set the
desired time in seconds.
5. To confirm the setting, press and hold the setting
buton until the second and temperature displays
stop flashing.
6. After setting the time and temperature, you can
close the press with the lever. Use the lever to pump
the cylinder upwards until both heating plates meet.
On the control panel you will see a counter that
shows the number of pressings so far.
Page 26.1