One for All URC10820N Guia Del Usuario página 10

Macro keys are ideal for home theater operations, setting a favorite
channel, guide steps, or other multiple functions you would like to
control with one key press. Moreover, each macro key can hold up
to a total of 20 key presses.
NOTE: Programming a new macro over an existing one will erase
the original macro.
Programming A Favorite Channel
With so many channels available through your cable or satellite
system provider, you can program a macro that directly selects a
favorite channel with one key press.
For example, let's assume your favorite cable programs are on
channel 52. Use the following instructions to program a macro key
for direct access of this channel:
NOTE: This example assumes the TV is tuned to the correct Input to
view your cable box.
Press and hold SET until the LED (red light) blinks twice, then
1.
release SET.
2. Enter 9 9 5. The LED will blink twice.
3. Select an open macro key (e.g., M1) and press it once.
4. Press CBL once.
5. Enter the channel number: 5 2.
NOTE: If you have access to over 100 channels, enter 0 5 2.
Moreover, if the original remote control requires you to press
ENTER to change the channel, also press ENTER after the
channel number (e.g., 0 5 2 ENTER).
NOTE: You can program up to 20 functions on the macro keys.
6. Press and hold SET until the LED blinks twice, then release SET.
Now when you press M1, you will instantly see cable channel 52
on your TV set.
Programming A Master Power Macro
In its default state, the POWER key on this remote will individually
power your home entertainment devices on or off. However, you
can also program a Master Power Macro onto the POWER key that
will sequentially turn on or off all the devices with a single key
press.
To Program the Master Power Macro
Press and hold SET until the LED (red light) blinks twice.
1.
2. Enter 9 9 5. The LED will blink twice.
3. Press the POWER key once.
4. For the first device you want in the power-on sequence, press
its device key (e.g., TV) once.
5. For the second device you want in the power-on sequence,
press its device key (e.g., CBL) once.
6. For the Third device you want in the power-on sequence, press
its device key (e.g., AUD) once.
7. Repeat step 6 up to seven more times to add the other desired
devices to the power-on sequence (e.g., SAT, VCR, DVD, CD,
PVR, AUX1 and AUX2).
To save the settings and exit the program, press and hold SET
8.
until the LED blinks twice, then release SET.
To Operate Master Power Macro
1. After programming, point the remote control at the devices
and press POWER for at least 2 seconds to sequentially turn on
(or off) your devices.
10