Changing Volume Lock - One for All URC10820N Guia Del Usuario

Press the learning key (e.g., L1) to be deleted twice. The LED
4.
will blink twice after the second press.
5. To clear additional functions stored on other learning keys,
repeat steps 1 through 4 (in this section).

Changing Volume Lock

This remote is set at the factory for independent volume control of
each selected device.
However, you may change the Volume Lock setting to Global
Volume Lock so that a device's volume will be locked to one mode
(e.g., to control TV volume in all other modes). After that, if
desired, you can perform Individual Volume Unlock on a selected
device to set its volume control for independent operation.
Locking Volume Control To One Mode
(Global Volume Lock)
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
Enter 9 9 3 and then press any mode key once (e.g., TV). The
2.
LED will blink twice.
3. Now, when you press VOL +, VOL -, or MUTE, the volume of
the selected device (e.g., TV) will be controlled regardless of the
mode you have selected.
Unlocking Volume Control For A Single Device
(Individual Volume Unlock)
1. After performing Global Volume Lock (see above), press a
desired mode key where you want volume to be unlocked (e.g.,
AUD) and controlled within its own mode.
2. Press and hold SET until the LED (red light) blinks twice, then
release SET.
Enter 9 9 3 and then press VOL - once. The LED will blink four
3.
times.
4. If desired, repeat steps 1 through 3 (of this section) for each
device that you want volume to be unlocked.
5. Now, after you select a device that has volume unlocked (e.g.,
AUD), pressing VOL +, VOL -, or MUTE, will control the device's
volume only in its own mode.
Unlocking All Volume Control
(Restoring Default Setting)
NOTE: Performing these instructions will restore independent
volume control for all programmed devices (e.g., TV volume control
in TV mode, VCR volume in VCR mode, etc.).
On the remote control, press and hold SET until the LED (red
1.
light) blinks twice, then release SET.
2. Enter 9 9 3 and then press VOL + once. The LED will blink four
times.
3. Volume will again be independently controlled according to its
default states for all programmed devices.
Using Macros
You can program the M1 ~ M3 keys on your remote to perform
repetitive, time-consuming operations for easy, convenient access
through the press of a single key.
9