Toto TLS01301U Manual De Instalación Y Del Propietario página 5

Drain
4. Remove the plunger, flange and
gasket from the drain assembly by
unfastening the flange and pulling
these parts from the drain.
Insert the drain body up thorugh the
drain hole from below the lavatory. If
necessary, turn the nut and push the
washer and gasket (thick) down to
allow for clearance.
While holding the drain body in
place, fasten the flange to the drain
body from the top. Ensure that the
gasket is between the flange and
the lavatory as shown. Once the
flange is fully seated, turn the nut
below the lavatory up until a good
seal is formed. Do NOT overtighten!
Reinsert the plunger if needed.
5. Prepare the pivot arm by
placing one bushing on each
side of the pivot ball as shown.
Insert the short end of the rod
into the drain body and through
the eyelet hole in the plunger.
Fasten the pivot ball nut to
secure.
Insert the drain lift rod and
pivot arm into the drain lift
rod connecting part.
Tighten both rods with
screwdriver.
INSTALLATION PROCEDURE
Flange
Gasket
(thick)
Tail pipe
Lever
hole
Bushings
Plunger
Short
end
Drain
lift rod
Screw
Pivot
arm
5
Plunger
Gasket
Washer
Nut
Body
Lever
screw
hole
Pivot Ball
Nut
Pivot Arm
Long
end
Drain lift rod
connecting part