Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FEATURES
A
B
C
Back View
A Crumb Tray
B Conveyor Speed Control Knob
C Power Knob
Full Power - maximum heat
Off
Standby - reduces electrical consumption by 75%.
D Heat Shield
E Feed Ramp
F Top Heat Control Knob
G Toggle Switch - Switches between heat modes
Top - Toasts the top side, warms the bottom side
Top-Bottom - Toasts both sides
H Bottom Heat Control Knob
I
Collection Pan
J Reset Button (Reference only. Access is via the front of the
toasters. See page 4.)

BEFORE FIRST USE

1. Clean the toaster. See "Cleaning" on page 3.
2. Insert the crumb tray. Make sure the feed ramp is placed in the up
position.
2
OPERATION
D
E
NOTICE: The crumb tray must be installed in the toaster during
F
Adjust the Heat Shield
G
Excess space above the product will create heat loss and may reduce
performance.
H
1. When the equipment is cool to the touch, use a screwdriver to
I
2. Grasp the shield and pull it up or down to adjust the opening so the
Front View
Preheat
1. Plug the toaster into a grounded electrical outlet that matches the
2. Set the toggle switch to Top-Bottom.
J
3. Rotate the power knob to the full power position (I).
4. Set the conveyor speed control knob to 7.
5. Set the Top and Bottom heat control to high.
6. Wait 5 minutes for the toaster to preheat.
Test
1. Adjust the settings for the product to be toasted.
Tips
Bread Product
Bagels, wheat or rye bread or
products with high moisture content.
Buttered or coated, such as pastries Not recommended.
Frozen
2. Test the settings by placing a sample of the product to be toasted
Toast
1. Adjust the heat control settings, toggle switch and conveyor speed
2. Turn off the toaster when not in use.
If an Item Becomes Stuck
1. Rotate the power knob to the OFF position (O) and unplug the
2. Let the equipment cool completely. Use tongs to remove the item.
Conveyor Toasters - 2,000 Slices Per Hour* Operator's Manual – Model JT2000
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
operation. Failure to install the crumb tray will cause the
toaster to overheat.
loosen the screw on the heat shield.
tallest products can pass through. Re-tighten the screw.
rating on the name plate found on the side of the toaster.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
onto the feed ramp. Place bagels or buns with the cut side facing up.
Bread: Set the toggle switch to Top-Bottom.
Buns/Bagels: Set the switch to Top.
as needed for desired results. Allow time for the toaster to adjust to
new heat settings before placing bread on the conveyor.
NOTICE: This toaster is designed for high-volume operations.
Leaving the toaster turned on while not in use could
cause the toaster to overheat.
equipment.
Take care to not bump the heating elements above and below the
conveyor.
Suggestions
Use a slower conveyor speed.
Must be thawed before toasting.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ct4-2082000Ct4-2202000Ct4-2402000

Tabla de contenido