Insert Batteries; Remote Sensor; Sensor Data Transmission - Oregon Scientific BAR806 Manual De Usario

Estação meteorológica solar
Ocultar thumbs Ver también para BAR806:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment.
2. Insert the battery, matching the polarities.
3. Select a channel. Press RESET after each battery
change.
4. Close the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
1.5 m (5 ft)
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
Press and hold
+ MODE.
The sensor reception icon in the remote sensor area
shows the status:
ICON
4
DESCRIPTION
Main unit is searching for
sensor(s).

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bar806a

Tabla de contenido