Connections; Connecting To Line Output (Pin Jack) Terminals Of The Amplifier - Yamaha YST-SW305 Manual De Instrucciones

Caution: Plug in the subwoofer and other audio/video components after all connections are
completed.
• All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Also refer to the owner's
manual for each of your components.
• Basically, connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. (Refer to pages 4 and 5 for details.)
If your amplifier does not have any line output terminal, connect the subwoofer to the speaker output terminals of the
amplifier. (Refer to pages 6 and 7 for details.)

Connecting to line output (pin jack) terminals of the amplifier

Connect the main speakers to the speaker output terminals of the amplifier.
• To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L/MONO INPUT2 terminal of the subwoofer.
I Using one subwoofer
Right main speaker
Subwoofer
Amplifier
4
E-

CONNECTIONS

OUTPUT INPUT AUTO PHASE +
2 STANDBY
TO SPEAKERS
+ – – +
/MONO
+ – – +
OFF HIGH
LOW NORM REV
FROM AMPLIFIER
INPUT
1
POWER
ON
OFF
+
To AC outlet
• When connecting the subwoofer to the SPLIT
SUBWOOFER terminals on the rear of the DSP amplifier,
be sure to connect the L/MONO INPUT2 terminal to the
"L" side and the R INPUT2 terminal to the "R" side of the
SPLIT SUBWOOFER terminals.
OUTPUT INPUT
2
TO SPEAKERS
– – +
/MONO
– – +
FROM AMPLIFIER
INPUT
1
SPLIT SUBWOOFER
SUBWOOFER
(LOW PASS)
Left main speaker
*Illustration shows YST-SW205.