SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or
install the product.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed, including the
following:
• Please retain manual and packaging for future reference, as these contain important
information.
• This is an electric product--not a toy! To avoid risk of fire, burns, personal injury and
electric shock, it should not be played with or placed where small children can reach it.
• This product is for indoor use only. Do not use outdoors!
• This product must not be electrically connected with another product.
• Do not use the product anymore if it is damaged.
• Remove all packaging before use unless the packaging has been adapted for display
purpose.
• Risk of electric shock! Do not use in the vicinity of water.
• Do not operate in vicinity of gas or electric heaters, open fires, candles or other heat
sources.
• Please check for damage prior to each use.
• Do not hang any object on the product.
• Protect the product from dust, humidity and extreme temperatures.
• The LEDs of this product are not replaceable!
• Make sure that each LED is properly set in each holder.
• Do not mix batteries of different types. Do not use new batteries with old ones.
• Remove the batteries from the battery compartment if you will not use the product for a
long period.
• Discharged batteries are to be removed immediately from the battery compartment in
order to avoid leakage.
• Remove leaking batteries immediately from the battery compartment.
• Caution: battery liquids are corrosive.
• Keep batteries away from fire, as they can explode or leak.
• The supply terminals are not to be short-circuited.
• Non-rechargeable batteries must never be recharged.
WARNING
To reduce the risk of electric shock or injury, keep electric wires clear of being pinched or
cut during assembly or installation. Discard sets with cut or damaged insulation.
CAUTION:
Risk of fire. This product does not contain lamp shunts, which allow the
product to operate if one lamp burns out.
2
2