WARNING:
• For indoor use only. Do not expose product or battery pack to moisture.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel-Cadmium)
batteries.
• Remove batteries when not used for an extended period of time, or when depleted.
Batteries will corrode over time and may cause permanent damage to unit.
• Do not use rechargeable batteries.
• Dispose of batteries properly by following directions on batteries.
This product works with 3 "AA" 1.5V batteries (sold separately).
Use alkaline batteries for best performance.
PREPARATION
Before beginning assembly of product, make sure all parts are present. If any part is
missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 5 minutes
Tools Required for Assembly: Phillips screwdriver
BATTERY INSTALLATION INSTRUCTIONS
In order for the light set to operate, batteries must be installed. See steps outlined below.
1. Loosen the screw on the battery
box with a Phillips screwdriver (not included).
3. Insert three 1.5V AA batteries (not included).
Make sure the batteries are placed in the
correct direction according to the polarity
markings inside the battery box.
2. Gently slide open the battery box
cover.
4. Re-attach the battery box cover
and tighten the screw back down
on the battery box.
3
3