Cordless Grease Gun
CAUTION
The Loader Fitting on the gun must mate with
the loader coupler. The pump may not operate
if the components are not compatible.
1. Pull the follower rod and engage the follower by rotating
the rod.
2. Seat the Loader Fitting into the loader coupler.
• Push down to hold the coupler valve open.
3. Operate the pump and view the movement of the follower
rod.
4. Discontinue pump operation once the groove on the
follower rod is visible.
5. Disengage follower rod from follower and push into the
Grease Cylinder.
Priming the Gun
In most cases the gun will prime simply by operating the
Trigger several times. Should grease fail to appear, air must be
bled.
Force Prime
This process manually assists air within the gun to be bled
at the Bleed Valve.
1. Pull the follower rod and engage the follower by
rotating the rod.
2. Depress Bleed Valve (45) and at the same time push on
the follower rod.
Once the air is eliminated, operate the gun several times.
Once grease appears, disengage the follower rod from the
follower and push into the Grease Cylinder.
Check Valve Contamination
Should the gun fail to prime; the outlet check may be
held open. Remove Plug (36), clean Ball (38), and the Ball
seat of Head (14).
Gun Operation
Battery (41) is intentionally shipped with a low charge.
Charge the Battery prior to use.
• Refer to the Battery Charger Operation section for
details.
CAUTION
The gun is equipped with software to protect the
motor. When a blocked bearing, line, or grease
fitting causes the gun to stall, the software will
cut power to the motor. If this situation occurs,
release the trigger immediately.
For maximum motor life, avoid operating at stall.
Alemite LLC
Battery and Charger Safety Rules
This manual contains important safety and operating
instructions for Battery part number 343432 and Battery
Chargers 343500 and 343501.
WARNING
Before using the Battery Charger read all
instructions and cautionary markings on Battery
Charger (42, 43), Battery (41), and products using
the Battery.
An extension cord should not be used unless
absolutely necessary. Use of an improper
extension cord could result in a risk of fire and
electric shock. If an extension cord must be
used, make sure it is 18- gauge. Check to ensure
that the pins on the plug of the extension cord
are the same number, size, and shape as those
of the plug on the Charger. Make sure that the
extension cord is properly wired and in good
electrical condition.
Do not incinerate the Battery, even if it is severely
damaged or completely worn out. The Battery
may explode in fire.
7
(Original Instructions) SER 586-A
Initial release (12-15)