Tripp-Lite DDR1327SDFC Manual Del Propietário página 5

3. Desk Installation
3a. Edge Installation
Note: min. desktop thickness=10mm (.4")
max. desktop thickness=90mm (3.5")
tighten
• Determine approximate location for mount, keeping in mind display size, height adjustment and pitch/roll
requirements.
• Slip the desk mount assembly over the edge of desk so that clamp fully contacts desk edge.
• Turn the knob to adjust the clamp to edge of desk and secure it tightly.
Note: If more secure clamping pressure is needed for thinner desktop surfaces, adjust the clamp adjustment
plate by removing the two screws from the desk clamp assembly, then align the clamp adjustment plate with
the desk clamp assembly's upper holes and reattach using the same screws.
5
14-06-220-93337E-revA.indb 5 7/24/2014 1:12:16 PM