Yamaha TX-592RDS Manual De Instrucciones página 11

AUTOMATIC PRESET TUNING
You can also make use of an automatic preset tuning function for RDS stations only. By this function, this unit performs automatic
tuning and stores RDS stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in
the manual preset tuning method on page 10.
To store stations
1
FM/AM
2
MEMORY
MAN'L/AUTO FM
MEMO
Flashes.
The automatic preset tuning begins from A1. Received
stations are programmed to A1, A2 ... A8 sequentially.
* If more than 8 stations are received, they are also
programmed to the preset station numbers on other groups
(B, C, D and E) in that order.
NATURAL SOUND
AM/FM STEREO TUNER TX–592RDS
STANDBY/ON
Press and hold for
more than 3 seconds.
AUTO ST
MHz
PRESET STATIONS
1 2 3 4
5 6 7 8
RDS MODE/FREQ PTY SEEK EON A/B/C/D/E MEMORY EDIT FM/AM TUNING MODE
MODE START MAN'L/AUTO FM AUTO/MAN'L MONO
2 1
When the automatic preset tuning is finished
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on page 10.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on page 10. A recalled station is shown by the
frequency or station name on the display.
Notes
The automatic preset tuning search is performed through all
RDS network frequencies until stations are stored up to E8.
If the number of received stations is not enough to be stored
up to E8, the search will be finished automatically after
searching all frequencies.
With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 10.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large
volume of PI (Program Identification) data along with the
station.
If no station is received by the automatic preset tuning
search, the search finishes after "NOTHING" flashes for
about 3 seconds on the display.
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section "To store stations" on page 10.
TUNING
PTY SELECTOR
11