Craftsman 125.ID20A Manual Del Usuario página 11

OPERATION FOR IMPACT DRIVER
grooves near the insertion ends that allow the
sleeve to grip the bit securely. Do not use any
other type of bit.
NOTE:
If the driver bit is not inserted deep
enough into the sleeve, the sleeve will not
return to its original position and the driver
bit will not be secured. In this case, try re-
inserting the bit according to the instructions
above.
NOTE:
After inserting the driver bit, make
sure that it is firmly secured. If it comes out,
do not use it.
NOTE:
Insert a socket adaptor into the
sleeve to use a socket with the impact driver.
BELT HOOK (AVAILABLE
SEPARATELY)
See Figure 7, page ii
A belt hook is available for separate
purchase. The hook enables you to
conveniently hang the tool from your belt
when tool is not in use.
Install the hook on either side of the tool.
Insert the tab of the hook into the slot in the
tool base. Secure the hook by tightening the
screw through the hole in the hook into the
hole in the base.
To purchase the hook, see Replacement
Parts on page 14 of this manual.
11 ― English