Glass Shelves; Odor Removal; Light Bulb Replacement - Kenmore 69872 Manual De Uso Y Cuidado

Light Bulb Replacement
4. Raise stabilizing legs (some models) by turning
counterclockwise.
CAUTION ]
Protect soft vinyl or other flooring with cardboard, rugs
I or other protective materiaI to avoid property damage.
5. Pull refrigerator away from wall. Run a vacuum
brush across grille on back of refrigerator.
Glass Shelves
I CAUTION
HandIe tempered gIass shelves carefuIIy to avoid
personal injury or property damage. Shelves may
break suddenly if nicked, scratched, or exposed to
sudden temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following:
•_ 1. Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let sit for 5 minutes.
2. Spray warm water into crevices using faucet spray
attachment.
3. Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering it from the front.
Odor Removal
1. Remove all food and disconnect power to
refrigerator.
2. Clean all interior surfaces including ceiling, floor, and
walls according to General Cleaning instructions
above. Pay special attention to corners, crevices, and
grooves. Include all drawers, sheives, and gaskets.
3. Connect power to refrigerator and return food to
refrigerator. Wash and dry all containers. Wrap foods
in tightly sealed containers to prevent further odor.
After 24 hours, check if odor has been eliminated.
Complete steps 4-9 if odor has not been eliminated.
4. Place crispers on top shelf of refrigerator section.
Pack refrigerator and freezer sections, including
doors, with crumpled sheets of newspaper.
5. Place charcoal briquettes randomly throughout
newspaper.
6. Close doors and let stand 24-48 hours.
7. Remove charcoal briquettes and newspapers.
8. Complete steps 2-3.
If odor is still not eliminated, contact a Sears Service
Center.
WARNING I
Disconnect power to refrigerator before replacing
light bulb to avoid electricai shock which can cause
severe personal injury or death. After replacing light
bulb, restore power.
CAUTION
Observe tile following to avoid personal injury or
property damage.
Allow light bulbs to cool
Wear gloves when replacing light bulb.
Remove light bulb cover by removing ¼" hex nut
screws. Replace with appliance bulb no greater
than 60 watts,
Replace light bulb cover by replacing ¼" hex nut
screws.
1/4" hex nut screws
Light cover
]4