Kenmore 69872 Manual De Uso Y Cuidado página 5

bladeor puttyknifebladewrapped inmasking
tape.Pryupbackedgeofhandle capandremove
fromhandle.
• Remove handle fromdoorbyremoving t wo
mounting screws.
• Remove 2 plugsfromopposite sideoffreezer
doorandreplace inemptymounting holes.
cap
Plug
Freezer
handle
3. Remove t ophingecover. Tophingecover s naps
off.Remove t ophinge andhingeshimusing hex
nutdriver. R emove a ndretainallshims.
4. Remove refrigerator doorbylifting dooroffof
centerhingepin. Inspect doorto verify allshims
arewithhingepin.
5. Remove center h ingepinusing hexnutdriver. D ue
totightfit ofpin,firmpressure m ayneedtobe
applied.Remove a ndretainallshims.
6. Remove f reezer d oorbylifting dooroffbottom
hinge.
7. Remove c enterhingebracket a ndhingeshim
usingPhillips screwdriver.
8. Remove t oegrilleandbottom hingecover.Both
snapoff.
9. Remove bottom hinge andhingeshimsusing hex
nutdriver.Remove a ndretainallshims.
5/16"_ H,t_
Tophinge screws Z_ __*--Hinge
_ shim(s)
5/16"
@*-- Round shim
Rexnut _--_
. .
Center hingephillips /!_tnter_L_"_ *-center h,nge h ingeP'n
screws_ _ bracket &
shim(s)
@4-- Round shim(s)
B.ott°mT _--_K''_''_'_---- H n e
hinge pin __ shi_(s)
Bottom hinge _ ] I
10. Reverse door stops.
• Locate door stop at bottom edge of refrigerator
door. Unscrew two Phillips screws to remove door
stop. Remove the two Phillips screws on opposite
edge of door. Mount door stop on opposite side.
Replace remaining screws in empty mounting
holes.
• Repeat the above instructions to reverse door stop
on freezer door.
door
1 1. Reverse doors by performing the following steps:
• Remove plugs and screws in opposite side of
refrigerator cabinet. Insert in holes left from hinge
removal.
12. Mount bottom, center, and top hinges with shims
on opposite side of cabinet.
• Replace bottom hinge on opposite side of cabinet.
Verify hinge shims are in position before screwing
into place. After placing hinge pin into outside
hole, replace round shims. Some bottom hinges
may have plugs in holes. In case of this, remove
plug from outside hole, put pin in hole, and replace
plug in empty hole.
• Replace center hinge bracket and hinge shim, and
screw into place.
• Hang freezer door.
• Replace center hinge pin with hex nut driver. Make
sure fit is tight. Replace round shims.
• Replace top hinge and shims, but allow enough
clearance to slide hinge side of refrigerator door
into place. Tighten down top hinge to securely hold
door.
• Use a dime at top to space door W_e"(18 mm)
from cabinet.
• Handle side of door should be approximately
V_"(3 mm) higher than hinge side. Boor will
become level when it is loaded with food.
118"
(3 mm) --
mm)
II'1
m