Heat Gun Operational Guidelines; Helpful Hints Prior To Use; Guidelines For Removing Paint - Homeright 800951 Manual Del Usuario

Heat Gun Operational Guidelines

HELPFUL HINTS PRIOR TO USE

• Keep the scraping tool edge clean to help make the
job easier.
• Do not use the Heat Gun on surfaces that can be
damaged by heat, such as vinyl, siding, gutters and
window frames.
• When removing paint from window frames, the Heat
Gun will soften the putty. Be careful not to gouge the
putty with the scraper. The putty will firm up after
it cools.
• Do not use the Heat Gun on insulated laminated
window glass such as Thermopane. The glass edge
expansion may break the edge seal.
• When scraping fascia, do not overheat the edges of
the asphalt shingles protruding over the edge of the
sheathing. Too much heat will melt the asphalt.
Removing paint with heat is safe, provided you follow
the guidelines below; however, you should always keep
either a container of water or an ABC fire extinguisher
within reach.

GUIDELINES FOR REMOVING PAINT

1. Move the work piece outdoors. If this is not possible,
keep the work area well ventilated. Open any available
windows and put an exhaust fan in one of them. Be
sure the fan is moving the air from inside to outside.
2. Remove or cover any carpets, rugs, furniture,
clothing, cooking utensils and air ducts. If they
cannot be removed, place in center of the room
and cover.
3. Place drop cloths in the area to catch any paint chips
or peelings. Wear protective clothing such as extra
work shirts, overalls and hats.
4. Work in one room at a time. Remove furnishings or
place them, covered, in the center of the room. Seal
the work area from the rest of the dwelling by sealing
doorways with drop cloths.
5. Children, pregnant women, women who are
considering becoming pregnant and nursing mothers
should not be present in the work area until the work
is done and all clean up is complete.
C800951 DIGITAL TEMPERATURE HEAT GUN
6. Wear a dust respirator mask or a dual filter (dust and
fume) respirator mask, which has been approved
by the Occupational Safety & Health Administration
(OSHA), the National Institute of Safety and Health
(NIOSH) or the United States Bureau of Mines. These
masks and replaceable filters are readily available
at major home center and hardware stores. Be
sure the mask fits. Beards and facial hair may keep
masks from sealing properly. Change filters often.
DISPOSABLE PAPER MASKS ARE NOT ADEQUATE.
7. Use caution when operating the Heat Gun. Keep
the Heat Gun moving, as excessive heat will generate
fumes, which can be unhealthy or dangerous
to inhale.
8. Keep food and drink out of the work area. Wash
hands, arms, and face and rinse mouth before eating
or drinking. Do not smoke or chew gum or tobacco in
the work area.
9. Clean up all removed paint and dust by wet mopping
the floors. Use a wet cloth to clean all walls, sills and
any other surfaces where paint or dust is clinging.
DO NOT SWEEP, DRY DUST OR VACUUM. Use a
high phosphate detergent or trisodium phosphate
(TSP) to wash and mop areas.
10. At the end of each work session, put the paint chips
and debris in a double plastic bag, close it with tape
or twist ties, and dispose of properly.
11. Remove protective clothing and work shoes while
still in the work area to avoid carrying dust into the
rest of the dwelling. Wash work clothes separately.
Wipe shoes off with a wet rag and then wash the
rag with the work clothes. Wash hair and body
thoroughly with soap and water.
ENGLISH 5