Assembly; Unpack Pressure Washer; Attach Handle, Cleaning Tank And Accessory Tray - Briggs & Stratton Power Boss Manual Del Usuario

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, please call the pressure washer helpline at
(800) 743-4115. If calling for assistance, please have the
model, revision, and serial number from the identification
label available.

Unpack Pressure Washer

1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit
• Handle
• Cleaning Tank
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting and Spray
Tip Holder
• Plastic Accessory Tray
• Oil Bottle
• Engine Operator's Manual
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 4 Multi–Colored Spray Tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• "L" Bolt
• Plastic Knobs (3)
• Tree Clips (6)
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle, cleaning tank and accessory tray to main
unit.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle extension.

Attach Handle, Cleaning Tank and Accessory Tray

1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with
holes (C) on handle supports.
C
NOTICE It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Place cleaning tank over holes on handle and handle
supports (viewing from rear of unit).
3. Insert carriage bolts (D) through top holes of the
handle, handle supports and cleaning tank from front of
unit and attach a plastic knob (E) from rear of unit.
Tighten by hand.
E
4. Push tree clips (F) into bottom holes (G) of cleaning
tank (H) and holes on handle supports until they sit flat
against cleaning tank.
H
A
B
D
G
F
7