Descargar Imprimir esta página

Coolaroo Simple Lift Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

B.
Insert the right side of the roller shade first. (Fig. 3)
C.
Install the left side of the shade by sliding the idle end into the mounting bracket. (Fig. 4)
D.
Once the roller shade is installed, remove the tape from the tension wheel component.
(Fig. 5)
E.
Pull down the shade until the red tensioning brake is completely removed. (Fig. 6)
3
RAISING AND LOWERING THE SHADE
Having successfully followed the steps above, your shade should be in the retracted position
(rolled up) and ready to use.
To lower the shade, place one hand in the center of the bottom rail and pull down to your
desired height.
To raise the shade, place one hand in the center of the bottom rail and gently guide the shade
up, as you lift the bottom rail upwards the shade will stop at the desired position once you
remove your hand from the bottom rail. (Fig. 7)
4
TENSION ADJUSTMENT
If the shade is not retracting to your desired speed use the steps below to
increase or decrease as needed.
A.
To increase the tension on the spring, turn the tensioning wheel
component 1-2 full rotations (counterclockwise) on the right side of the
shade. (Fig. 8)
B.
To decrease the tension on the spring, turn the tensioning wheel
component 1-2 full rotations (clockwise) on the right side of the shade.
(Fig. 8)
Note: Be sure to save the tension wheel brake after removing it to make readjusting the
shade easier. If you misplace your tension wheel brake, you may still reset the shade to
its factory setting by rotating the tensioning wheel towards the + sign,
19-21 full rotations.
Fig.8
To prevent damage, roll up your sun shade when not in use, or before strong storms.
MAINTENANCE: Your sun shade has been made of the finest materials and, when properly cared
for, will provide years of shade and privacy. To clean your shade, simply rinse with water, scrub with
mild soap or any nonabrasive cleaner, rinse and allow to dry. Call us for missing parts or mechanical
problems. Do not store shade wet. In moist areas, roll shade down frequently to air dry.
CAUTION: Use of solvents or abrasive cleaners may damage the fabric and will void your warranty.
Do not use bleach or chlorine.
Questions or Comments? Contact us at:
Gale Pacific USA, Inc. | www.coolaroousa.com | 1-800-560-4667
© by Gale Pacific Limited. All rights reserved. Coolaroo® is a registered trademark of Gale Pacific Limited.
Fig.7
ADDITIONAL
TENSIONING
MAY BE
REQUIRED AFTER
INSTALLATION
Register and Order
Replacement Parts Online:
www.coolaroousa.com
5.04.004.270
Fig.3
Fig.4
Fig.5
Fig.6

Publicidad

loading