Chamberlain 942FP-10 Manual Del Usuario página 3

Step 5 Programming
NOTE: The unit must have an enrolled user before it can be
programmed to the receiver. Due to the 30 second time interval, a
second person may be needed to press the
"SMART" actuator.
1. Remove the front panel of the receiver
case. Press and release the "SMART"
actuator on the receiver. The "SMART"
indicator light will glow steady for 30
seconds.
2. Open the Fingerprint Keyless Entry cover
and wait for Ready LED to light.
3. Within 30 seconds of pressing the
"SMART" actuator, slowly and fi rmly
swipe enrolled fi nger.
NOTE: The Retry LED will light if another
swipe is needed.
4. After a passed swipe the Pass LED will
light followed by a lit Send LED.
Programming is complete.
5. If the opener does not operate, press and
release the Resend button at 1 second
intervals for up to 5 seconds until the door
moves. Programming is complete.
NOTE: If unit will not program to opener
repeat the steps above or refer to
Troubleshooting.
Step 6 Operation
1. Open cover and wait until Ready LED is
lit.
2. Swipe fi nger slowly and fi rmly down the
sensor strip.
2
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY
3. The Pass LED will fl ash and garage door
will either open or close.
3
NOTE: If cover is already open, press either the Resend or the
Enroll button to turn unit on. The Fail or Retry LED will light if
4
another swipe is needed. If this occurs, swipe slowly and with
ENROLL
more pressure. It may require multiple swipes to get a passed
SEND ENROLL
swipe.
PASS FAIL
READY RETRY
While the door is traveling the Send LED will be lit. During this
time the only way to reverse or stop the door is to press the
Resend button.
5
3
1
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY
2
3
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY