Descargar Imprimir esta página

Sears Kenmore Elite 146. 33577410 Manual De Uso página 24

Publicidad

Idiomas disponibles

Idiomas disponibles

Left Side burner
□ Remove plastic packaging from side burner valve. Remove side burner grate from within
side burner shelf.
□ Connect flat igniter wire tip to the igniter pin on the side burner valve. (A & B)
□ Remove the 2 pre-installed screws from the valve control stem and set them aside. (C)
□ Loosen the side burner to insert gas valve. To loosen, remove the two screws on front bracket,
and loosen the rear bracket screws halfway. (D&E)
□ Insert the gas valve into the side burner (F), and insert the valve control stem through the hole
in shelf fascia. (I)
□ Replace side burner front bracket and tighten in place with 2 previously removed screws. (G)
Tighten screws on back bracket. (H)
Install previously removed 2 screws .Note:Do not tighten these 2 screws until the bezel is attached
to fascia and valve face.(I).
Attach bezel to facial and valve face with the installed screws .First attach one side key hole of
bezel to the screw ,then attach the other one to the other screw.Make sure the black mark faces
up.(J). Tighten the 2 screws .(K)
□ Push control knob onto side burner valve stem. (L) Replace side burner grate. (M)
□ Connect the round igniter wire tip to the pin on the white electrode protruding from the bottom
of the side burner shelf. (N)
24·33577-41500319
A
C
E
B
D
F

Publicidad

loading