Parts list
Parts list
A Film aerial (x1)
C Cable clamper (x3)
Cautions for installation
The film aerial A is exclusively for use inside the vehicle.
0
Do not install at the following locations:
0
- where it may block the driver's view.
- where it may obstruct the operation of safety devices such as air bags.
- on movable glass surfaces such as the rear hatch.
- at side of vehicle (e.g. door, front quarter window).
- on rear window.
Signal strength will weaken when installed at the following locations:
0
- on IR reflecting glass or locations covered with mirror type glass film.
- where it overlaps with genuine radio aerial (pattern).
- where it overlaps with window heating wires.
- on glass that blocks radio signals (e.g. IR reflecting glass, thermal insulation glass).
Do not bend or damage the film aerial A.
0
Do not apply any glass cleaner after pasting the film aerial A.
0
It may not be possible to install on certain vehicles.
0
Memo
Poor reception may occur:
- due to noise when the windscreen wiper, air conditioner, or motor is turned on.
- depending on the direction of the broadcast station with respect to the vehicle (aerial).
2
| ENGLISH
B Cable (3.5 m) with booster (x1)
D Cleaner (x1)