Blower Operation - Craftsman CMXEVBCB1260L Manual De Instrucciones

ENGLISH
Assembly Instructions
20. To remove portable blower 3 from tank cover, pull
blower latch down to unlock blower 3 Fig. 5, grasp
both blower handles and pull in an upward motion.
Fig. 6.
Fig. 5
Fig. 6
21. Insert 2-1/2" extension wand 11 (B) into the blower
exhaust (A). Push firmly into place by twisting wand 11
slightly. Attach desired accessory (C). Fig. 7.
A
22. Plug the cord into an electrical outlet. Your portable
blower 3 is ready for use. NOTE: If an extension cord is
used, use only an approved outdoor extension cord. To
prevent extension cord from pulling away from appliance
cord, tie cords as shown. Fig. 8.
5
B
C
Fig. 7
Fig. 8
23. To clean inlet shield and foam pad, disconnect cord from
receptacle and remove screws on bottom side of power
unit. Fig. 9.
Fig. 9
24. Once removed, run foam pad under running water and
blot with clean towel to dry.
25 After cleaning, replace inlet shield and foam pad and
secure with screws. NOTE: Inlet shield will only fit properly
one way. Fig. 10.
Fig. 10

CAUTION:
BLOWER WITHOUT INLET SHIELD AND FOAM IN
PLACE.

BLOWER OPERATION

26. The correct operating position is to hold the portable
blower 3 in either hand, at arms length at your side.
Your portable blower 3 has been designed with the
necessary angle to direct the air blast toward the ground
in front of you. Fig. 11.
Fig. 11
DO NOT OPERATE