Be Cool BC6AC2001FTL Operación Manual página 21

FILLING THE WATER TANK
The air cooler can be filled with water in two different ways:
TOP OF THE APPLIANCE (TOP
LOADER)
Open the cover at the top of the appliance
and pour water into it:
Water
Always observe the MIN and MAX markings when filling the water:
 MIN mark  The water tank must be filled to above the MIN mark so that
the pump can function properly
 MAX mark  The water tank must not be filled over the MAX mark, otherwise
water could enter the inside of the appliance and thus damage electronic parts.
Close the cover again.
COOL PACKS
You will receive two cool packs that can be put into the water tank for a further cooling effect.
When using the cool packs, please note the following:
1. Before use, place the cool packs in a freezer for at least 3-4 hours.
2. The water tank should be filled with water before inserting the cool packs.
3. When inserting the cool packs into the tank, make sure that the MAX mark is not
exceeded.
When doing so, please make sure that the MAX mark is not exceeded.
NOTE
Ice cubes can also be filled into the water tank.
Seite 21 von 145
BACK OF THE APPLIANCE:
Push the blowout latch located above the
water tank upwards, so that the water tank
can be filled:
Make sure the water tank is not damp or
wet on the outside, and if so, wipe it dry.
Then carefully push the tank back into the
air cooler and turn the safety latch back.
Water