Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
appliance is connected to the electrical
outlet, it is recommended to put the safety
switch in the "OFF" position. To start
working, set the (2A) switch to the "ON"
position and press the steam button
(Fig.4a).
The first burst of steam may contain some water
droplets, due to imperfect thermic stabilization
inside the flexible hose. We would therefore
advise that the first jet of steam is sprayed onto
an old cloth until a constant pressure of steam is
obtained.
Note: The steam pressure indicator light (K)
may go on and off from time to time during use
of VAPORETTO. This indicates the machine
maintains the correct and constant pressure and
is quite normal.
STEAM REGULATION FEATURE
VAPORETTO is equipped with a steam flow
regulator control (I) (Fig. 5). You can increase
the steam flow by turning the control in an
anti-clockwise direction. Turning it in a clockwise
direction reduces the steam flow. Here are some
suggestions for the choice of steam flow level:
• Strong steam: for encrusted dirt, stains,
sanitizing, grease.
• Normal steam: for carpets, rugs, glass, tiles
etc.
• Delicate steam: for vaporizing plants and
cleaning delicate fabrics, upholstery, wallpaper
etc.
CONNECTION OF ACCESSORIES
All the accessories of VAPORETTO can be
connected to the handle or to the extension
tubes as per the following instructions (fig. 6):
1b. Move the locking button (11) on the
accessory to the "open" position.
2b. Attach the required accessory to the steam
gun (2) or to the extension tube (7).
3b. Move the locking button (11) back to the
position 'closed'.
4b. Check that the locking button has engaged
and the accessory is fully connected.
VAPORETTO ECO POWER
10
USE OF THE ACCESSORIES
HOLDER
The accessories holder allows to fix the tube
with the brush mounted on it on the appliance
body.
Make the groove on the back of the brush slide
into the guide of the accessories holder on the
appliance (Fig. 7).
PRESSURE INDICATOR
Vaporetto is equipped with a pressure indicator
(L) displaying operating pressure.
PATENTED SAFETY CAP /
''WATER OUT''
Steam may cause serious injury if in
contact with body parts. Always allow the
steamer to cool down before handling.
The appliance is equipped with a patented
safety cap, which prevents opening of the
generator boiler tank as long as there is any
pressure remaining inside. This is an important
and indispensable safety device, and it is
necessary to follow the procedure here below
when re-filling the boiler tank.
The 'water out' is indicated by a warning light
(J).
When you have used up all the water in the
boiler, proceed as follows:
1c. Switch off the machine at the generator
on/off switch (B)
2c. Press the steam request lever (3) on the
steam gun (2) or, if using the professional
iron, the steam request button (Q1) on the
professional iron (Q) so as to fully exhaust
the steam supply from the tank.
3c. Switch OFF the accessory on/off switch (C).
4c. Disconnect the power supply cable (F) from
the electrical outlet.
5c. Unscrew anti-clockwise the patented safety
cap (A)
6c. Wait at least for 7 minutes to allow the boiler
tank to cool down.
7c. When cool proceed to carefully refill the
boiler as described in paragraph 1 of the
Publicidad
Tabla de contenido
