Troubleshooting - Zanussi ZNFN18FS1 Manual De Instrucciones

that break away before defrosting is complete.
Use the supplied ice scraper for this purpose.
5. When defrosting is complete, dry the interior
thoroughly. Keep the ice scraper for the future
use.
6. Switch on the appliance and close the door.
7. Set the temperature regulator to obtain the
maximum coldness and run the appliance for at
least 3 hours using this setting.
Only after this time put the food back into the
freezer compartment.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates con-
tinually.
PERIOD OF NON-OPERATION
When the appliance is not in use for long period,
take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent unpleasant
smells.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on.
The temperature in the appli-
ance is too high.
The door is left open.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door Open Alarm" or
"High Temperature Alarm".
Refer to "Door Open Alarm" or
"High Temperature Alarm".
Close the door.
Refer to "Control Panel" chap-
ter.
Wait a few hours and then
check the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before stor-
ing.
13