Installing Star-Type Centering Guides; Removing Star-Type Centering Guides; Installing The Seesnake; Compact, And Flatpack Ball-Type Centering Guides - RIDGID SeeSnake Serie Manual Del Usuario

SeeSnake

Installing Star-Type Centering Guides

1. Position a centering guide and two c-rings over the
spring, with the centering guide between the c-rings
(Figure 21).
C-Rings
Figure 21 – Guide and C-Rings Positioned On Spring
Assembly.
2. Position the opening in the centering guide 180 de-
grees opposite the opening in the c-rings ( Fi -
gure 22).
3. Press the c-rings into the grooves on each side of
the centering guide until the c-rings snap into place.
It's easiest if you place the closed portion of the c-
ring into the groove and work toward the open end
(Figure 22).
Closed Side
of Rings
Figure 22 – Press the c-rings into the grooves on the
centering guide. Make sure the openings in
the c-rings are 180 degrees opposite the
opening in the pipe guide.

Removing Star-Type Centering Guides

1. Pry off each c-ring with the tip of a flat blade screw-
driver inserted near the open end of the ring and
the base of the spikes (Figure 23).
Figure 23 – Place flat tip of screwdriver between c-ring
and base of spike and pry c-ring out of
groove.
12
® Compact and Color Compact
Open Side of Guide
2. Slide the c-rings and centering guide over the camera
head.
If further assistance is needed, please call the Ridge Tool
Company, Technical Service Department at (800) 519-
3456. Replacement guides can be ordered from your
RIDGID dealer.

Installing the SeeSnake

FlatPack Ball-Type Centering Guides
Ball-type centering guides consists of two halves that are
pre-assembled at the factory, and two steel clips that
hold the guide in place on the spring.
Figure 24 – Centering guides improve vision by allow-
ing the camera to see an equal amount of
pipe wall in all directions and by raising the
camera out of sludge. They also reduce
wear on the LED window.
Retaining Rings
Locked
Figure 25 – Retaining Rings in Locked Position
® Compact, and