GE GFDL110 Manual Del Propietário página 14

Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Remove
Top Screw
8-#10 Tapping Screws
2 Beauty Buttons
4-# 8 Machine Tapping Screws
Outer Door Assembly
Hinge Cover
Hinge Assembly
14
Remove Door Assembly
2. Open the door to approximately 130 degrees.
3. Remove the 4 screws starting from the bottom to the top. Make sure the door is
supported while removing the screws.
4. Loosen the top screw as shown. Unhook the door by lifting and pulling.
5. Place the door on a soft protected flat surface so the inner door faces upward
(door resting on handle side). Remove the 8 tapping screws located around the
perimeter of the door outlining the gasket. Remove the 4 machine screws.
Remove Hinge and Cover
IMPORTANT: Note the location of the hinge (left or right) before removing.
6. With the screws removed, turn the door over and separate the outer door
assembly and hinge cover of the door from the door frame and set aside.