Electrical Connections - Craftmade Kona Bay K52 Manual Del Usuario

13
Operation Instructions
1. The sequence of operation for the motor pull/chain switch is OFF-HI-
MED-LOW.
2. Push the slide switch RIGHT for FORWARD, and LEFT for REVERSE
action of the blades.
3. The pull chain switch for the lighting is two positions - ON/OFF.
Slide Switch
CAUTION
Even if your fan is mounted with the blades more than 7 feet from the floor, be
careful to avoid placing your raised arms or any object in the path of the blades.
Motor Pull Chain
Light Pull
Chain
14

Electrical Connections

Connect black and blue (if provided) fan wires to black outlet wire. Connect
white fan wire to white outlet wire and green grounding lead wire from the
grounding conductor to the supply circuit (see figure A). Use wire connectors
provided with your fan. No loose strands or loose connections should be
present. After wires have been connected, they must be spread apart so the
green and white are on one side of the outlet box and the black and blue
are on the other side. Turn
splices upward and carefully
push all wiring into outlet
box. For optional wall
Noir
control see figure B or
Figure C for alternate wiring.
When wall switches are employed,
switches should be UL listed
for use with ceiling fan.
NOTE: Make sure fan on/off switch
is always at "high speed" location if
your fan is controlled by additional
wall switch.
White
Black
Light Switch
Figure B
Fil de terre
Blanc
Bleu
Vert
Figure A
Ground
Black
Green
Blue
White
Vert
Blanc