Go Rhino 917000T Instrucciones De Instalación página 5

INSTALLATION INSTRUCTIONS
STEP # 2
•Assemble the mounting base with the
front and rear tubes as shown. Use the
spacer specified with the front and rear
tube.
•Attach each tube to the mounting base
using (2) " flat washers, (2) " lock washers
and (2) " x 1 " hex bolts, per side.
•Do not install items 11 and 12, cover
plates, if a bed cover is going to be used.
•Do not fully tighten bolts, leave loose for
final adjustments.
© 2016 Go Rhino Products. All rights reserved