Introduction - Eddy TBE3 Instrucción Y Mantenimiento Manual

Introduction

RESUME
Due to prolonged and demanding physical effort that requires manual removal of ceramic tiles, cements and
glues, we have developed a tool allowing the operator to have a better posture and this for all phases and
materials to be removed.
ERGONOMICS
An ergonomic tool for removing ceramic floor covering with a design focused on reducing physical effort and
improving the health and safety of (/prevention of injuries to) the operator.
Thanks to its geometry that allows a wide range of attack angles to remove various floor coverings at an optimum
handle height, the Tile Breaker tool provides a comfortable working condition to the operator.
GENERAL DESCRIPTION
The system consists of an impact tool, angle adjustment and positioning system, foldable handle with a switch
and control knobs, foot push plate, wheels and chisels 1'', 2'' and 3''.
ANGLE ADJUSTMENT
The electric actuator allows the positioning of the tool to the different necessary angles for the work to be done.
On the opposite side of the actuator, we have added a graded sticker and needle showing the degrees of the
tool to the operator. For example, an angle of plus or minus 30 degrees is used for the removal of ceramic tiles
rather than an angle of 70 degrees used to remove the grout. This rule then becomes a reference point for the
operator.
The electric actuator is connected to a Up & Down switch integrated in the handle which allows the safe
positioning of the tool without manual effort.
Page | 7