Dometic PERFECTROOF PR4500 Instrucciones De Uso página 16

Ocultar thumbs Ver también para PERFECTROOF PR4500:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 71
Operating the awning
6.6
Changing the batteries in the wind sensor
I
NOTE
When the batteries of the wind sensor are running low, the wind sensor
indicates this with a brief beep tone which is repeated every 5 seconds.
The awning also retracts automatically after 30 minutes, even if it is not
windy.
➤ Extend the awning if required.
➤ Move the wind sensor (fig. 5 1, page 4) on the inside of the front cover to the
left and take it off.
➤ Release the sensor insert with a screwdriver (fig. 6 A, page 4).
➤ Remove the sensor insert from the housing (fig. 6 B, page 4).
I
NOTE
Do not use rechargeable batteries.
➤ Replace the used batteries with new AAA or LR03 (1.5 V) alkaline batteries
(fig. 6 C, page 4). Make sure the polarity is correct.
✓ After correctly inserting the new batteries, the LED (1) lights up for about 1 second
(fig. 6 D, page 4).
If the LED does not light up, remove the batteries and reinsert them correctly
(fig. 6 C, page 4).
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of them at
collection points.
➤ Test the wind sensor (chapter "Testing the wind sensor" on page 14).
➤ If the wind sensor does not work, reprogramme it (chapter "Reprogramming the
wind sensor" on page 18).
16
PR4500
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido