RIDGID RT16000 Manual Del Usuario página 7

ASSEMBLY
Attaching / Removing
Powerhead Assembly to
Dust Drum
1. Place Powerhead Assembly on top of
Dust Drum with the Extended Lip of the
Powerhead Assembly aligned with the
Inlet. Be sure Powerhead Assembly is
fully seated on the Dust Drum.
Powerhead
Assembly
Extended
Lip
Dust
Drum
Vac Inlet
2. Install: Press in on the two Latches
located on either side of the Dust Drum
until they snap into place, securing the
Powerhead Assembly to the Dust Drum.
3. Remove: Pull out on the two Latches
and lift Powerhead Assembly from the
Dust Drum. Do not force the Latches to
rotate more than slightly outside Drum
flange.
Powerhead
Assembly
Latches
(2)
Vac Inlet
Locking Accessories
1. To Connect
RIDGID Wet/Dry Vac includes Locking
Accessories to prevent the Accessories
from falling off when in use. To
connect the Accessories, align the
Nozzle Ridges of the Accessory with
the Release Button of your Extension
Wand. Press to secure the Nozzle to
the Extension Wand.
CONNECT:
Accessory Nozzle
Ridges
2. To Disconnect Accessory: Twist
the Nozzle and Extension Wand to
disengage the Nozzle Ridges and pull.
You may also press the Release Button
and pull to disengage.
DISCONNECT:
Accessory Nozzle
Ridges
7
Accessory: Your
Extension Wand
Release Button
Extension Wand
Release Button