Thermostat - GE Zoneline AZ91H18D*E Owner’s Manual

Installation Instructions
AND LOW VOLTAGE CONTROL CONNECTIONS
To Connect the wall-mounted thermostat
the chassis.
the main breaker panel or the closet mounted
disconnect.
panel.
connections on the right side of the control.
5. Make the wire connections per the instructions
that are included with the thermostat.
6 Once each wire is matched and connected, the unit is
now ready for operation.
Thermostat terminals requirements
For cooling with electric heat units: C, R, GL, Y, W.
For heat pump units: C, R, GL, Y, W, B.
For two fan speeds, thermostat must have 2 fan
speed selection.
Heat Pump Units During Heat Mode:
Electric Heat mode.
CAUTION
Common busing is permitted. A separate wire pair
must be run from each separate controlling switch
49-5000431 Rev. 1
REMOTE THERMOSTAT
Terminal Connection
on unit
FP F2 F1 D2 D1 C GH GL B
Electronic
Control
Terminal Wire Connection Function
Code
FP Factory use only.
(Ensure there is not jumper at FP
and F2)
F2
no jumper at FP and F2)
C
GH Call for High Fan
GL Call for Low Fan
B Call for Heat Pump Reversing Valve
Y Call for Compressor
W Call for Heating
R
Y W R