Taurus HC-0150 Manual Del Usario página 23

- At regular intervals, stop cutting in order to comb the hair and
check the results so far.
STEP 1 – NAPE:
- Attach the comb guide size 3 / 6 mm.
- Hold the appliance with the razor facing downwards and begin to
cut the hair from the base of the neck.
- Make some upward movements, raising the appliance gradually
and away from the head, cutting the hair gradually until the height
of the ears (Fig.3).
STEP 2 – BACK OF HEAD:
- Attach comb guide size 9 / 12/ 15 /18 mm and continue with the
back of the head (Fig.4).
STEP 3 – SIDE OF HEAD:
- Attach the longest comb guide size 9 / 12 / 15 / 18 mm again and
continue until you reach the top of the head.
STEP 4 – TOP OF HEAD:
- Using comb guide size adjusted to desired height, pass the
appliance from the back to the front, against the growth of the hair
(Fig.5). In some cases, it's necessary to go over what you have
done a second time from front to back.
- The comb guide size 3 / 6 mm is for when you want to achieve a
more precise cut.
- Use comb guides size 9 / 12 /15 /18 mm to leave hair at a longer
length. Hold the hair up with the comb or the comb and your
fingers and cut.
- Always work form back to the front reducing the length between
your fingers or the comb and the head gradually.
STEP 5 – FINAL TOUCH:
- Finally use the appliance without attaching any comb guides to
the blades to cut the hair around the base of the neck, the sides of
the neck and the ears.
- To make sideburns straight, turn the appliance over to use the
upper blades (Fig.6). Move the appliance adapting it the physiog-
nomy of the head. To achieve more precise results, use a shaver.
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
- Turn the appliance off using the on/off button.
- Unplug the appliance from the mains.
- Clean the appliance.