Poulan Pro PPB150E Manual De Instrucciones página 9

ON/OFF Switch
HOW TO START YOUR UNIT
WAR NIN G:
Avoid any contact with the
muffler. A hot muffler can cause serious bums.
. _ k_ Starting Position
@5
HELPFUL TIP I
ff your engine still does not
I start after following these I
instructions, pleas e call
1-800-554-5723.
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle trigger
until the engine has started and runs.
1. Set unit on a flat surface.
2. Move ON/OFF switch to the ON position.
3. Slowly press the primer bulb 6 times.
4. Move the start lever to the START posi-
tion.
Handle
Start
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the ON/OFF switch in the ON position. Move
the start lever to the RUN position and fully
squeeze throttle trigger. Pull the starter han-
dle repeatedly white squeezing throttle trigger
until engine starts and runs. This could re-
quire puIHng the starter handle many times,
depending on how badly the unit is flooded.
if the unit still doesn't start, refer to
TROUBLESHOOTING TABLE or call
1-800-554-6723.
OPERATING THE COUPLER
This mode] is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
MODEL:
Edger ...................... PPB1000E
Cultivator ................... PPB2000T
Blower ..................... PPB3000B
Brushcutter ................. PPB4000C
Pruner ..................... PPB5000P
_ WARNING: Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING TRIMMER ATTACH-
MENT (OR OTHER OPTIONAL AT-
TACHMENTS)
CAUTION: When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Upper Shaft
Coupler
Lower \
Attachment
Primer Bulb
Muffler
5. Pull starter rope handle sharply until en-
gine starts and runs.
6. Altow unit to run for 5 seconds, then fully
squeeze the throttle trigger to disengage
the starting system.
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON position.
2. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
engine runs smoothly.
3. Pull starter rope sharply while squeezing
throttle trigger until engine runs.
NOTE: Normally. the warm starting proce-
dure can be used within 5-10 minutes after
the unit is turned OFR If the unit sits for more
than 10 minutes without being ran. it will be
necessary to start the unit by following the
steps under STARTING A COLD ENGINE or
following the starting instruction steps shown
on the unit.
TIGHTEN Knob
Press and hold the locking/release button.
Locking/Release
Button
/
Lower Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
merit (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
9