Installing Hardware; Cpu Socket 775 - Abit IP35 Manual De Usuario

1.7 Installing Hardware

DO NOT scratch the motherboard when installing hardware. An accidental
※
scratch of a tiny surface-mount component may seriously damage the
motherboard.
In order to protect the contact pins, please pay attention to these notices:
※
1. A maximum 20 cycles of CPU installation is recommended.
2. Never touch the contact pins with fingers or any object.
3. Always put on the cap when the CPU is not in use.

1.7.1 CPU Socket 775

The installation procedures vary with different types of CPU fan-and-heatsink
※
assembly. The one shown here is served for demo only. For detailed
information on how to install the one you bought, refer to its installation
guidelines.
1. Place the board so that the lever-hook of
the socket is on your left side. Use your left
thumb and forefinger to hold the lever hook,
pull it away from the retention tab. Rotate
the lever to fully open position.
2. Use your right-thumb to raise the load
plate. Lift it up to fully open position.
IP35/IP35-E
3. Use your right thumb and forefinger to
grasp the CPU package. Be sure to grasp on
the edge of the substrate, and face the Pin-1
indicator toward the bottom-left side. Aim at
the socket and place the CPU package
vertical down into the socket.
4. Visually inspect if the CPU is seated well
into the socket. The alignment key must be
located in the notch of package.
1-9