Operating Instructions - Stanley SHP 2000 Instrucciones De Montaje, Cuidado Y Uso

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
• Turn on water supply at the faucet to completely
open.
• Make sure the "ON/OFF" switch is in the "OFF"
position. The power switch has international
symbols for 'on' and 'off': On (|) Off (O).
• Unwind the power cord completely and plug the
GFCI into a grounded 120 volt outlet.
• Unlock trigger of the spray gun. While pointing the
spray gun in a safe direction, squeeze the trigger on
the spray gun until there is a steady stream of water,
letting the water and air out of the hose. Once air
and water are out of the gun, lock the trigger on
the spray gun.
10
93906_16ARN028_2000_ENG-FR-SP.indd 10
OFF/0
ON/I
• Turn the power switch to the "ON" (|) position. The
unit will turn on for 1 - 2 seconds and shut off. This is
a normal function of the auto start feature. Squeeze
the spray gun trigger to begin pressure washing.
• Begin power washing by squeezing the trigger on the
spray gun all the way into the handle.
• Release the spray gun trigger to stop the power
washer
• Allow the motor to come to a complete stop before
squeezing the trigger again.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning
on while squeezing trigger after rapid squeezing. Use
slow deliberate trigger pulls to avoid such symptoms.
• a small area to avoid chance of
Always test
damaging the surface.
OFF/0
ON/I
16/12/14 下午5:48