Care And Maintenance - Stanley SHP 2000 Instrucciones De Montaje, Cuidado Y Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS

CARE AND MAINTENANCE

Cleaning Garden Hose Adapter
• The screens inside the garden hose adapter should
be cleaned periodically. Rinse it with clean water,
and then place it back in the adapter.
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while
spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by
squeezing the trigger 2-3 times, and then lock the
spray gun.
• Using the nozzle tip cleaner provided (or an
unfolded paper clip), insert the wire into the
nozzle hole and move back and forth until debris is
dislodged.
• Back flush water through the nozzles using garden
hose and highest pressure available (either standard
water nozzle or use your thumb over the nozzle to
93906_16ARN028_2000_ENG-FR-SP.indd 13
create water pressure for back flush).
Storage
• When your pressure washing session has been
completed, turn off the power switch located
on the front of the power washer. Unplug the
power cord from the outlet. Turn off the water
supply. Pull the trigger on the spray gun 2-3 times
to drain out the excess water and to release any
remaining water pressure. Disconnect the garden
hose adapter from the water inlet.
the power washer to run with no water flowing
through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and
can cause the detergent injector to clog and not
function properly.
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the
holder on the side. Lances are placed into any of
the slots in the back of the unit. Make sure to
discard any remaining detergent from the bottle.
Flush the bottle and nozzle head with fresh water
to prevent clogging.
• Hook the power cord around the L-shaped tabs on
the right side of the machine when facing it.
allow
DO NOT
13
13
16/12/14 下午5:48

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido