Precautions For Safety - Toshiba Carrier MMK-AP0157HPUL Manual De Instalación

1

PRECAUTIONS FOR SAFETY

• Ensure that all Local, National and International regulations are satisfied.
• Read this "PRECAUTIONS FOR SAFETY" carefully before Installation.
• The precautions described below include the important items regarding safety.
Observe them without fail.
• After the installation work, perform a trial operation (test run) to check for any
problem.
Follow the Owner's Manual to explain how to use and maintain the unit to
the customer.
• Turn off the main power supply switch (or breaker) before the unit
maintenance.
• Ask the customer to keep the Installation Manual together with the Owner's
Manual.
The manufacturer shall not assume any liability for the damage caused by not
observing the description of this manual.
General
• Before starting to install the air conditioner, read through the Installation
Manual carefully, and follow its instructions to install the air conditioner.
• Only a qualified installer(*1) or qualified service person(*1) is allowed to
do installation work. Inappropriate installation may result in water leakage,
electric shock or fire.
• Do not use any refrigerant different from the one specifled for complement or
replacement. Otherwise, abnormally high pressure may be generated in the
refrigeration cycle, which may result in a failure or explosion of the product or
an injury to your body.
• Before opening the front panel of the indoor unit or service panel of the
outdoor unit, set the circuit breaker to the OFF position. Failure to set the
circuit breaker to the OFF position may result in electric shocks through
contact with the interior parts. Only a qualified installer(*1) or qualified
service person(*1) is allowed to remove the front panel of the indoor unit or
service panel of the outdoor unit and do the work required.
• Before carrying out the installation, maintenance, repair or removal work, be
sure to set the circuit breaker to the OFF position. Otherwise, electric shocks
may result.
• Place a "Work in progress" sign near the circuit breaker while the installation,
maintenance, repair or removal work is being carried out. There is a danger
of electric shocks if the circuit breaker is set to ON by mistake.
• Only a qualified installer(*1) or qualified service person(*1) is allowed to
undertake work at heights using a stand of 19.7" (50 cm) or more or to
remove the front panel of the indoor unit to undertake work.
• Wear protective gloves and safety work clothing during installation, servicing
and removal.
• Do not touch the aluminium fin of the unit. You may injure yourself if you do
so. If the fin must be touched for some reason, first put on protective gloves
and safety work clothing, and then proceed.
5-EN
WARNING
– 5 –
Installation Manual