Remote Control; Installation; Operation; Setup - Omnitronic CMP-101 Manual Del Usuario

4.3 Remote control

5. INSTALLATION

(1) Install the CD player on a plane surface or in your rack.
(2) Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
(3) Remove the protection foil from the display.
(4) Please note that the LC display can only be read from an angle of 45° to the top and of 5° to the bottom.
(5) Rack installation: This CD player is built for 19" racks (483 mm). The rack you use should be a double
door rack where you can open the front panel and the rear panel. The rack should be provided with a
cooling fan. When mounting the CD player into the rack, please make sure that there is enough space
around the device so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD player with four screws M6 in the rack. Be aware that fastening the device with four
screws on the front panel is not enough. In order to ensure safety, additional fastening by using ground
and side bars is necessary.
(6) CAUTION: Make sure that the CD player is switched off (power switch in outer position) before you
connect it to the mains in order to avoid damages on your loudspeakers.
(7) Connect the CD player with the RCA cable to your mixer via the Audio Out sockets. Make sure that the
right/left occupation (plug colour red/white) is the same at both devices.
(8) Make sure that the indication on the Voltage selector corresponds to the available voltage in order to
avoid severe damages. Only plug the power plug into safety sockets. Connect your CD player with the
mains.

6. OPERATION

6.1 Setup

Switch the CD player on via the Power switch. If no CD is inserted, „NO DISC" appears on the display.

6.2 CD tray

(1) Press Open/Close button in order to open the disc tray. The CD tray opens and the display shows
"OPEN". Insert your CD in the CD tray. Make sure you only hold the CD with two fingers on the edge.
Avoid touching the inside area of the CD.
(2) CAUTION: Do not close the tray by pushing it as this could harm the construction.
(3) Press the Open/Close button again in order to close the tray.

6.3 LC display

After inserting the CD, the total number of tracks and the total playback time are shortly displayed.
The buttons on the Remote control have the same
functions as on the player's front panel.
Additionally, the Remote control has the following
functions:
Numbers and +10 button:
By pressing the respective number, you can call
up the track number directly. For tracks higher
than 9 you first have to press the +10 button and
then the missing number.
19/43 00030404.DOC, Version 1.0