Safety Instructions; Environment Concerns - Progress PDK9031E Manual De Instrucciones

Safety instructions

For lamp replacement use only lamp type
indicated in the Maintenance/Replacing
lamps section of this manual.
Warning! Do not connect the
appliance to the mains until the
installation is fully complete.
With regards to the technical and safety
measures to be adopted for fume
discharging it is important to closely follow
the regulations provided by the local
authorities.
The ducting system for this appliance must
not be connected to any existing ventilation
system which is being used for any other
purpose such as discharging exhaust
fumes from appliances burning gas or other
fuels.
Do not use or leave the hood without the
lamp correctly mounted due to the possible
risk of electric shocks.
Never use the hood without effectively
mounted grids.
The hood must NEVER be used as
a support surface unless specifically
indicated.
Use only the fixing screws supplied with the
product for installation or, if not supplied,
purchase the correct screws type.
Use the correct length for the screws which
are identified in the Installation Guide.
In case of doubt, consult an authorised
service assistance centre or similar qualified
person.
Warning! Failure to install the screws
or fixing device in accordance with
these instructions may result in
electrical hazards.

Environment concerns

Recycle the materials with the symbol
. Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to
recycle waste of electrical and electronic
appliances. Do not dispose appliances
marked with the symbol with the
household waste. Return the product to
your local recycling facility or contact your
municipal office department for household
waste or the shop where you purchased
this product.
Use
The hood is designed to be used either for
exhausting or filter version
Installation
The mains power supply must correspond
to the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area, after installation. If it not
fitted with a plug (direct mains connection)
or if the plug is not located in an accessible
area, after installation, apply a double
pole switch in accordance with standards
which assures the complete disconnection
of the mains under conditions relating to
over­current category III in accordance with
installation instructions.
Warning! Before re-connecting the
hood circuit to the mains supply and
checking the efficient function, always
check that the mains cable is correctly
assembled.
progress 13
.