Haier QDHR20 Manual Del Propietario Y Instrucciones De Instalación página 8

USING THE DEHUMIDIFIER
Always make sure the water bucket is locked into place on the dehumidifier.
Removing Collected Water
There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed, the unit will shut
off. Empty and replace the bucket.
IMPORTANT: Do not use the hose if using the bucket to collect
water. When the hose is connected, water will flow through it
onto the floor instead of into the bucket.
NOTES:
• Do not remove the bucket while the dehumidifier is operating
or if it has just stopped operating. This might cause some
water to drip from the drain pan.
• The bucket must be in place and securely seated for the
dehumidifier to operate.
Water Level
The dehumidifier will turn off automatically when the bucket is
full, or when the bucket is removed or not replaced in the proper
position.
Bucket Operation
DO NOT remove the foam piece and magnet block in the bucket
assembly. If removed the Dehumidifier will not work properly.
8
Use a hose. Water can be automatically emptied into a floor
drain by attaching a garden water hose (not included).
1. Remove the bucket from the front of the unit.
2. Open the drain cover on the side of the unit.
3. Thread a garden hose (not supplied) onto the nozzle and
ensure it is seated securely. Cut to length and lead it to the
floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely seated for the
dehumidifier to operate. The drain hose must run down from the
dehumidifier to the floor drain.
The bucket must be replaced in the proper position for the
dehumidifier to work. The empty indicator will blink and the
dehumidifier will not run if the bucket is not in the proper
position.
49-5000430 Rev. 3