Aspes ACT1680 Manual De Instrucciones página 5

INSTALLATION
WALL DRILLING AND BRACKET FIXING
C
Vertical reference line
As a first step, proceed with the following drawings:
A vertical line up to the ceiling or up to the upper limit, at the center of the area in which the hood

is to be fitted.
A horizontal line A at 970 – 1070 mm above the cooker top.

A horizontal line B at a X mm above the horizontal line A.

A horizontal line C at a 243 mm below the horizontal line A .

Mark Points:
Mark a point (1) on the horizontal line A, 80 mm to the vertical reference line.

Repeat this operation on the other side and on the vertical reference line, checking that the

three marks are leveled.
Mark a point (2) on the horizontal line B, 60 mm to the vertical reference line.

Repeat this operation on the other side, checking that the two marks are on the same

horizontal line.
Mark a point (3) on the horizontal line C, 100 mm to the vertical reference line . Repeat

this operation on the other side , checking that the two marks are leveled.
Fix the brackets :
Drill holes at the marked points with a ɸ10 mm drill bit.

Insert the Wall Plugs 11 into the holes.

Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) at the horizontal line A.

Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) at the horizontal line B.

100
100
(3)
EN-5
Option Chimney
1
400X390 160-500
2
500X490 260-700
3
600X590 360-900
X