Important Safety Instructions - Angelcare AC527 El Manual Del Propietario

Ocultar thumbs Ver también para AC527:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

provide the supervision necessary for the continued
safety of your child
• Use this appliance ONLY for its intended use as
described in this manual
15. The Sensor Pad is not intended to be used
to determine if a child is out of the crib
16. ALWAYS be sure to immediately check on
baby whenever an alarm sounds
17. Keep cords out of the reach of ANY
children
18. ONLY use the chargers and power
adapters provided. Do not use other types as
this may damage the device and battery pack
(if included in your model)
19. Adult assembly required. Keep small parts
away from children when assembling
20. Follow instructions and test this monitor
and its functions so you are familiar with it
prior to actual use. ALWAYS be sure that both the
transmitter and receiver are working properly and
are within range of each other – check periodically
and when changing location of the Nursery Unit
21. DO NOT touch the plug contacts especially
with sharp or metal objects
22. DO NOT use the baby monitor near water
Care should be taken so that objects DO NOT fall
onto units and that liquids are not spilled into either
unit or Sensor Pad through its openings
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DO NOT EXPOSE TO RAIN OR MOISTURE
23. Keep monitor AWAY from heat sources
(such as stoves, radiators, etc.). Heat can
damage the case or electrical parts
24. ALWAYS place both the Nursery Unit and
the Parent Unit on a flat solid surface in
an upright position that allows for proper
VENTILATION. DO NOT place on sofas, cushions,
beds, etc. which may block ventilation or anywhere
that would muffle the sound or interfere with the
normal flow of air
25. The baby monitor can only be used
between 10°C and 40°C (50°F and 104°F)
WARNINGS AND SAFETY
INSTRUCTIONS - BATTERY
SPECIFIC
26. ALWAYS keep all batteries away from children
27. The Parent Unit battery is a replaceable
Li-Ion battery. The Wireless Sensor Pad uses
a replaceable Button Cell Lithium Battery.
Only use the Angelcare recommended
replacement battery (see Technical
Specification)
• Danger of explosion if the wrong battery is used
or if replaced incorrectly. Refer to User's Guide for
correct battery installation
• DO NOT short circuit supply terminals
28. DO NOT mix old and new batteries and only
use Angelcare recommended replacement
batteries (see Technical Specification)
29. This product contains a Button Cell Battery
and if swallowed can cause internal chemical
burns in as little as two hours and lead to
death. Dispose of used batteries immediately.
Keep new and used batteries away from
children. If you think batteries might have
been swallowed or placed inside any of the
body, seek medical attention.
30. The Button Cell Battery represents a small part
and a choking hazard – KEEP away from children!
31. Exercise care in handling batteries in order
not to short out the batteries with conducting
materials such as rings, bracelets and keys
32. Overcharging, short circuiting, reverse
charging, mutilation, or incineration of
batteries must be avoided to prevent one or
more of the following occurrences: release of toxic
materials, release of hydrogen and/or oxygen, gas
and rise in surface temperature
33. DO NOT attempt to recharge batteries
provided with or identified for use with this
product that are not intended to be charged
The batteries may leak corrosive electrolyte or
explode
34. Incorrect polarity installation of the
batteries in the end product must be avoided
Reverse insertion of batteries can cause charging,
and that may result in leakage or explosion
35. Remove batteries from units if you store
the product over 30 days because the batteries
could leak and damage the product
36. Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, discard
product responsibly
37. DO NOT store this product, or the
batteries provided with or identified for use
with this product, in high-temperature &
high humidity environments and avoid direct
sunlight

IMPORTANT SAFETY INSTRUCTIONS

38. Sensor Pad –
• If your crib does not have a solid, stationary,
completely flat, firm surface including a spring or
slat base, place a hard board between the crib base
and the Sensor Pad, to ensure correct operation
(see specification on STEP 2)
• The Sensor Pad functions with standard crib sprung
and foam mattresses and not memory foam (partial
or full), hollow frame construction mattresses and
water beds. Please consult Angelcare if unsure of
mattress compatibility
39. This monitor uses public airwaves to transmit
signals. The Parent Unit may pick up signals or
interference from other nursery monitors in your
area. Your monitor may even be picked up by other
households. To protect your privacy, make sure both
E
E
N
N
3
3

Publicidad

Tabla de contenido
loading

Tabla de contenido