How To Assemble Your Ceiling Fan Blades And Cap - Fanimation KUTE 52 FPD8534 Serie Manual De Instrucciones

How to Assemble Your Ceiling Fan Blades and Cap

1. Align blade holes with posts on the motor assembly
flywheel. Make sure the blade is fully seated against
the flywheel. Place blade plate over the blade with
holes aligned and assemble blade to flywheel using
serrated head screws, Fully tighten the screws that
attach the blades to the motor assembly flywheel.
(Figure 1)
HARDWARE USED:
3/16"-24
Serrated
Head Screw
Blade Plate
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
2. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later and slightly loosen the
remaining two screws. (Figure 2)
3. Assemble the light plate assembly to the support
bracket using the two key slots in the light plate
assembly. Replace the previously removed screw and
securely tighten all three screws. (Figure 3)
4. Remove one of the three screws in light plate
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 4)
5. Assemble the light kit wire cover to the light plate
assembly using the two key slots in the light kit wire
cover. Replace the previously removed screw and
securely tighten all three screws. (Figure 5)
3/16˝-24
Serrated
Head Screw
(3 each per blade)
X 9
X 3
Motor
Assembly
Light Plate
Assembly
Light Kit
Wire Cover
12
Figure 1
Figure 2
Motor Assembly
Light Plate
Assembly
Figure 3
Figure 4
Figure 5
Motor Assembly
Blade Plate
Blade