Silca Air 4 V Manual De Instrucciones página 5

Air
4
ATTENTION: before copying make sure the original remote control is working properly.Check the
state of the ba ery.
COPY FIXED CODES :
1.
Press and hold down bu on 1 on the "Air4 V" remote control and at the same me press
bu on 4 four mes.
3.
about every 2 sec.
4.
Press and hold down the bu on to be copied from the original remote control and wait for
the "Air4 V" LED to start fl ashing rapidly, which confi rms that the code has been acquired. This
opera on may take a few seconds.
which the code must be transferred and hold down un l the LED goes out.
N.B. •If the LED goes out unexpectedly it means the code has not been acquired. Repeat the
opera on from point 1.• To programme the second "Air4 V" bu on, repeat the opera on from
point 1.
COPY ROLLING CODE NORMAL* :Follow the "Fixed Code" instruc ons.
COPY ROLLING SECURE LEARNING* :
1.
Press and hold down bu on 1 on the "Air4 V" and at the same me press bu on 4 four
mes. 2. Release both bu ons: the "Air4 V" LED will fl ash briefl y about every 2 sec. 3. Place the
remote control to be cloned back to back with the "Air4 V". 4. Press and hold down the bu on
to be copied from the original remote control and wait for the "Air4 V" LED to go on without
fl ashing and then start double fl ashing about every 2 seconds.
control source code (check the website www.silca.biz to fi nd the one for the remote control you
6.
want to copy). The "Air4 V" LED will fl ash rapidly; press the bu on by which the code will be
memorised and hold down un l the LED goes out.
(*) Full list of original models at: www.silca.biz.
N.B.: Transmit the source code to copy an "Air4 V" remote control programmed as "Rolling Secu-
re Learning".
PROCEDURE A.L.S.:Simplifi ed procedure to ac vate the remote control on the receiver. The list
of receivers compa ble with the procedure can be found on www.silca.biz. For other receivers
see the original instruc ons provided by the manufacturer.
N.B.:Follow A.L.S. procedure before using the original remote control.
1.Stand close to the automa on 2.Hold down the programme bu on for about 10 seconds;
release when the LED starts to fl ash 3.Wait un l the LED goes out.
ATTENTION : receivers may have the radio channel disabled. In such cases enter the new re-
mote controls using a manual procedure.
TRANSMISSION OF "Air4 V" SOURCE CODE :
1.Press bu ons 1 and 2 on the remote control simultaneously for 8 seconds and release when
the LED fl ashes.2.While the LED is fl ashing press the bu on for which the source code is requi-
red.
Ba ery replacement: Use a star screwdriver to loosen the screw on the back of the "Air4 V" re-
mote control.The "Air4 V" remote control is powered by a 3V CR2032 LITHIUM BATTERY. Check
polarity-Do not throw fl at ba eries away: dispose of them in the special waste sor ng centres.
2. Release both bu ons: the "Air4 V" remote control LED will fl ash briefl y
Place the remote control to be cloned back to back with the "Air4 V".
5.
While the LED is fl ashing, press the "Air4 V" bu on to
Copyright Silca S.p.A 2017
English
5.
Transmit the original remote
ENGLISH
5