BLACK&DECKER 11BDE-210 Manual De Instrucciones página 11

3. Fill the tank (J) with suitable
cleaning solution.
7
V
4. Place the Click-N-Clean
lance into the Low Pressure Soap
position (S, fig. 4).
5. Squeeze the trigger and the
detergent
be mixed with the water and
dispensed from the nozzle.
NOTE: When
nozzle is moved to the High Pressure
Medium or High Pressure Wide Fan
Spray position, detergent will not be
dispensed.
6. When you have completed the
use of detergent, Fill and flush the
detergent tank with clear water
after use. See Storage for correct
procedure.
7. See Storage section in this manual
for proper shutdown and storage
procedures
Cleaning techniques
When cleaning with the pressure washer,
some cleaning tasks can be solved with
water alone, but for most tasks it is
advantageous to use a detergent. A
detergent ensures a quick soaking of
the dirt allowing the high pressure water
to penetrate and remove the dirt more
effectively.
j
spray
®
will automatically
the Click-N-Clean
Application of detergent
CAUTION: Avoid working on hot
surfaces or in direct sunlight to mini-
mize the chance of the soap damaging
painted surfaces.
CAUTION: Damage may occur to
painted surface if soap is allowed to dry
on the surface. Wash and rinse a small
section at a time.
1. Apply the solution to a DRY work
surface.
NOTE: WETTING THE SURFACE
FIRST IS NOT RECOMMENDED,
AS IT DILUTES THE DETERGENT
AND REDUCES ITS CLEANING
ABILITY.
On a vertical surface, apply soap
horizontally from side to side
starting from the bottom to avoid
streaking.
®
2. Allow detergent to remain on the
surface for a short time before
rinsing.
3. Rinse with clean water under high
pressure. On a vertical surface,
first rinse from the bottom up, then
rinse from the top down. Hold
nozzle 6–8 in. (15–20 cm) from the
work surface at a 45° angle using
the flat spray as a peeling tool
rather than a scrub brush.
NOTE: Ensure that the detergent
injection system is completely clean
prior to switching from one detergent
to another.
STARTING (FIG. 8–14)
DANGER: Risk of injury from spray.
Always engage the trigger lock when
gun is not in use. Failure to do so could
cause accidental spraying.
WARNING: Risk of Injury. Do not
direct discharge stream at self or others.
WARNING: Risk of unsafe operation.
Stand on a stable surface and grip gun/
spray wand firmly with both hands.
11 - ENG